I have JBL speakers connected to it, and for the past few months, every time I've turned it on, it comes on for a second with a little bit of hissing in the speakers, and then there's a loud POP and the speakers are silent, and the display on the Carver. Howdy, I have a Carver HTR-880 Home Theater Receiver, and I've had it for several years. The amplifier shall be capable of bridge-mode operation thereby providing 700W RMS output into 8 ohms and supplying a 70-volt distribution system without output matching transformers.
8-ohm FTC rated power/ch 200W 4-ohm FTC rated power/ch 300W Bridged mono power 700W 4/8-ohm FTC rated THD 0.5% IM Distortion less than 0.1% Input Impedance (Line) 15k ohm Input Sensitivity 1.5Vrms Gain 28.5dB Rated full power bandwidth +0, -3dB at 5Hz & 80kHz Slew Rate 25V/u sec Power Consumption 950 Watts Fusing 8 amp slo-blo Damping 200 at 1kHz Dimensions (HxWxD inches) 3.5' x 19' x 11.56' Architect's and Engineer's Specifications The power amplifier being of two channels, shall deliver 200W into 8 ohms with both channels operating, or 300W into 4 ohms with both channels operating.
